Nerd Herd
  • Home
  • Deliverables
  • Meet the Team
  • Our Design Process

Track our progress

10/26/14 Progress and Results

10/26/2014

 
Picture
Picture
At this point, we have created a minor hardware design using our resistors, pressure sensors, and lilypad board. We connected a pressure sensor to one resistor, which was also connected to the lilypad board. Using light sensors that were also connected to the lilypad board, along with an Ardublock code written by Jacob and Taylor, whenever the pressure was applied to the pressure sensor, the light would go on permanently. This was the result we were looking for and will stand as good rough draft for our design. From here, we will expand on the code and add more lights so that when pressure is applied, the lights will go on in intervals to show that pressure is being applied for a certain amount of time. 
Picture

Comments are closed.

Powered by
✕